An Overview of False Alarms in Toxic Gas Detection Systems in San Jose, CA

November 30, 2016 1:56 am Published by Leave your thoughts

Gas detection systems in San Jose, CA are designed to pick up on potential toxic gas leaks to keep every person in your facility safe, which is why it’s crucial that you have the right gas detection device in place. This is not only because hazardous gases have the power to knock out an entire workforce, but because many are also flammable. From gas poisoning to fires and explosions, gas detection alarms must be taken seriously, no matter what—including false alarms. But even though the alarms might be false, you cannot allow employees to stop reacting to them.

As a reminder to everyone working in your facility, here’s an overview of false alarms produced by toxic gas detection systems in San Jose, CA.

What is a false alarm?

We’ve all probably encountered a false alarm either at home or at our place of employment. The most common type of false alarm is the smoke detector going off. That loud beeping is meant to be annoying in order to alert you to the presence of smoke, but when you don’t see smoke, you may go looking for a source that’s not there. False alarms lead to panic, and in an office building or factory, it’s likely to bring out the fire department.

But for your facility that’s around any number of gases, alarms—though they may be false—can be extremely scary. A toxic gas detector is a device installed to alert everyone on site that a dangerous level of a specific hazardous gas has been detected; in some instances, that gas is not actually loose in the air.

Main causes of false alarms

  • Your gas detector could be reacting to a certain hazardous gas, which may create an electrical noise or signal that leads to a false alarm. This is also known as cross-sensitivities caused by a chemical reaction.
  • Maintaining your gas detection system plays a huge role in whether or not false alarms occur—especially since sensors can lose their sensitivity after a certain amount of time. This means they are more likely to malfunction and produce false alarms on a regular basis before completely dying off. Depending on the manufacturer, sensor life is typically 6 to 24 months, but with scheduled maintenance services, you can have them replaced well before they start losing their accuracy.
  • Another possible cause of false alarms in your facility is the age of the detection device. Old technology and equipment may have proven worthy for a good length of time, but you want to consider replacing your old system with a newer, more efficient one to stop nonsensical alerts and to ensure workplace safety.

When you own one of many gas detection systems in San Jose, CA, you are responsible for keeping it maintained. Your employees depend on you to keep them safe at the workplace, which is why you should schedule regular system maintenance and sensor checks with the experienced team at MDC Systems, Inc. Don’t hesitate to call us with questions or to make an appointment!

Categorised in:

This post was written by Writer

Leave a Reply

Your email address will not be published. Required fields are marked *